User Manual

81-42
Figure 81-8 Create BGP MPLS VPN between PE-CE via EBGP
The configuration of CE1 is as follows : (the configurations of CE2~CE4 are similar)
CE1#config
CE1(config)# interface vlan 1
CE1(config-if-Vlan1)#ip address 10.1.1.1 255.255.255.0
CE1(config-if-Vlan1)#exit
CE1(config)# router bgp 65001
CE1(config-router)#neighbor 10.1.1.2 remote-as 100
CE1(config-router)#redistribute connect
CE1(config-router)#exit
The configuration of MPLS BGP on switch PE1 is as follows:
(1) Configure VPN instances
PE1#config
PE1(config)#ip vrf vpna
PE1(config-vrf)#rd 100:1
PE1(config-vrf)#route-target both 100:1
PE1(config)#ip vrf vpnb
PE1(config-vrf)#rd 100:2
PE1(config-vrf)#route-target both 100:2
(2) Configure to bind the interface with the VPN instances
PE1(config)# interface vlan 1
Loopback1
172.2.2.2./32
VLAN3：
10.3.1.2/24
AS 65001
VPN A RT:100:1
VLAN1：
10.1.1.1/24
VLAN1：
10.1.1.2/24
VLAN2：
10.2.1.2/24
VLAN2：
10.2.1.1/24
CE2
VPN-B
RT:100:2
AS 65002
PE 1
CE1
VLAN100：
100.1.1.1/24
VLAN100：
100.1.1.2/24
VLAN200：
200.1.1.2/24
Loopback 1：
172.3.3.3/32
P
MPLS backbone
VLAN200：
200.1.1.1/24
VLAN3：
10.3.1.1/24
AS 650003
VPN-A RT:100:1
PE2
CE4
VPN-B
RT:100:2
AS 65004
VLAN4：
10.4.1.2/24
VLAN4：
10.4.1.1/24
AS 100
PE-CE USING EBGP
CE3
Loopback1
172.1.1.1/3
2