User Manual

81-38
3) Enable OSPF in the segment between PE-CE
4) Configure to re-advertise BGP routes
5) Enter the BGP-VPN instance view
6) Configure to re-advertise OSPF routes
7) Advertise local private network routes
Command
Explanation
BGP Protocol Configuration Mode
neighbor <ip-address> remote-as
<as-num>
necessary
Configure the remote PE as the public
network VPNv4 neighbor. It’
s suggest to
select loopback interface to set up the BGP
neighbor among public network PE.
neighbor <ip-address> update-source
<as-num>
Point the local loopback interface for set up
neighbor.
Enter the BGP-VPNv4 view
address-family vpnv4 [unicast]
necessary
Create BGP VPNv4. No VPNv4 is created
by default.
[no] neighbor <ip-address> active
optional
Activate all neighbors in VPNv4. All
neighbors in VPNv4 view are active by
default.
Global Configuration Mode
[no] router ospf [<process_id> [<vrf-
nam>]]
optional
Create the
OSPF instance between
PE-CE, and enter the Router OSPF view.
OSPF VPN instance view
[no] network {<network> <mask> |
<network>/<prefix>} area <area_id>
optioanal
Enable OSPF in the
segment between
PE-CE. Enabled in no segment by default.
[no] redistribute { bgp | connected |
static| rip | kernel} [ metric-type {1 | 2}]
[tag <tag>] [metric <cost_value>]
[router-map <WORD>]
optional
Configure to re-advertise the BGP routes.
No re-advertisement of any rou
te by
default.
BGP Protocol Configuration Mode
[no] address-family ipv4 {unicast|
multicast|vrf <vrf-nam>}
optional
create BGP VPNv4 and enter the
BGP-VPN instance
view. No VPNv4 is
created by default.