User Manual

2-9
 Approved PLANET SFP Transceivers
PLANET Managed Switch supports both Single mode and Multi-mode SFP transceiver. The following list
of approved PLANET SFP transceivers is correct at the time of publication:
Gigabit SFP Transceiver modules:
■ MGB-SX SFP (1000BASE-SX SFP transceiver / Multi-mode / 850nm / 220m~550m)
■ MGB-LX SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 10km)
■ MGB-L30 SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 30km)
■ MGB-L50 SFP (1000BASE-LX SFP transceiver / Single-mode / 1310nm / 50km)
■ MGB-LA10 SFP (1000BASE-LX SFP transceiver / WDM Single-mode / TX: 1310nm, RX: 1550nm/
10km)
■ MGB-LB10 SFP (1000BASE-LX SFP transceiver / WDM Single-mode / TX: 1550nm, RX: 1310nm /
10km)
It recommends using PLANET SFPs on the Managed
Switch. If you insert a SFP
transceiver that is not supported, the Managed Switch will not recognize it.
The XGS3-24042 supports both 1000Base-X and 100Base-FX
SFP transceiver by
manual setting and the default SFP port speed is set to 1000Mbps. To establish
the fiber
connection with 100Base-
FX SFP transceiver, the following command configuration is
required:
XGS3-24042#config
XGS3-24042(config)#interface ethernet 1/0/24
XGS3-24042(config-if-ethernet1/0/24)#speed-duplex force100-fx
Before connect the other Managed Switches, workstation or Media Converter.
1. Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX
to 1000Base-SX, 1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type match the SFP transceiver model.
 To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable-with one side must be
male duplex LC connector type.
 To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must
be male duplex LC connector type.
 Connect the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation
or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP
transceiver is operating correctly.
4. Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media
Converters, set the Link mode to “1000 Force” is needed.
 Remove the transceiver module
1. Make sure there is no network activity by consult or check with the network administrator. Or through the