User's Manual
78
the information frame sent by the opposite end exceeds the acknowledged maximum size, an acknowledge
frame will be sent immediately rather than at the timeout. The command below can be used for setting the
value.
Command Purpose
llc2 ack-delay-time
seconds Setting the acknowledgement time-delay
7.3.10 Setting the Maximum Numbers of Acknowledgement
When the information frame sent by the opposite end exceeds the maximum number of acknowledgement in
the process of acknowledging the time delay, the acknowledgement frame shall be sent immediately for
clearing the network timeout perceived by the opposite end. The command below can be used for setting the
value.
Command Purpose
llc2 ack-max
number Setting the acknowledgement time-delay.
7.3.11 Showing LLC2 Link Information
Command Purpose
show llc interface
[
type
number] Used for showing the related information of LLC2 link
connection.
Configuration Mode: Interface, configuration and global
Notes:
Showing the related information of LLC2 link connection. Under interface mode, the command
“show llc” is used for displaying LLC2 link information of the interface.
Example: Under interface mode, the command “show llc” is used for showing llc2 information on ethernet1/1.
int ethernet1/1
sho llc ethernet1/1
7.3.12 Debugging LLC2 Link Information
The command is
Command Purpose
debug llc2
[
packet
|
error
|
state
] Used for opening LLC2 debug switch.
Configuration mode: Management Mode
Notes:
packet
,
Opening the debug switch of LLC2 link status information
Example, opening the debug switch of LLC2 link.
debug llc2 packet
debug llc2 state
debug llc2 error