User's Manual

58
Example
The following example shows a main.bin file is read from the server, written into the SWITCH and changed
into the name switch. Bin.
monitor#copy tftp flash
Prompt: Source file name[]?main.bin
Prompt: Remote-server ip address[]?192.168.20.1
Prompt: Destination file name[main.bin]?switch.bin
please wait ...
######################################################################
######################################################################
######################################################################
######################################################################
######################################################################
#############################################
TFTP:successfully receive 3377 blocks ,1728902 bytes
monitor#
4.1.5 Updating configuration
The SWITCH configuration is saved as a file, the filename is startup-config. You can use commands similar to
software update to update the configuration.