Manualshelf

User's Manual

ManualsBrandsPLANET Technology ManualsLAN SwitchesLayer 3 48-Port 10G SFP+ + 2-Port 40G QSFP+ + 4-Port 100G QSFP28 Managed Switch
541542543544545546547548549550
543
COMMAND
Purpose
ipv6 traffic-filter WORD { in | out } Filters the IPv6 packets in the reception or
transmission direction (in: receive; out:
transmit) on a VLAN interface.
7. Setting IPv6 Hop-Limit
Users can designate a router to transmit the value of the hop-limit field in the packets (except those
forwarded packets). All those packets that this router transmits out, if the upper-level application does not
apparently designate a hop-limit value, use the set value of hop-limit. At the same time, the value of the
hop-limit field is added to the RA packets that this router transmits.
The default hop-limit value is 64. If you want to change this value, you can run the following command in
interface configuration mode.
COMMAND
Purpose
ipv6 cur-hoplimit value
DESIGNATES A ROUTER TO
TRANSMIT THE HOP-LIMIT FIELD
OF THE PACKETS.