Manualshelf

User's Manual

ManualsBrandsPLANET Technology ManualsLAN SwitchesLayer 3 48-Port 10G SFP+ + 2-Port 40G QSFP+ + 4-Port 100G QSFP28 Managed Switch
531532533534535536537538539540
540
automatically.
ipv6 address fe80::x link-local Sets a link-local address
manually.
Note:
The link-local address must begin with fe80. The default length of the prefix is 64 bit. At
manual settings only the values at the last 64 bits can be designated.
On a VLAN interface can only one link-local address be set.
After IPv6 is enabled through the configuration of the link-local address, IPv6 only takes
effect on the local link.
To set a global IPv6 address in VLAN interface configuration mode, run the following commands.
Command Purpose
ipv6 address autoconfig Sets a global address
automatically.
ipv6 address [ipv6-address/prefix-length | prefix-name
sub-bits/prefix-length] | [eui-64]
Sets a global address.
ipv6 address X:X:X:X::X/<0-128> anycast Sets an address of
unicast/broadcast/multicast.
Note:
(17) When IPv6 is enabled through the configuration of a global address, all interconnected IPv6 device can
be handled by IPv6.
(18) If a link-local address has not been set before the configuration of the global address, the system will set
a link-local address automatically.