User's Manual

422
on a serial interface (and the interface is connected with a Packet-switched Network), you have to prohibit
Split-Horizon to all routers in any relevant Multicast Group on that Network.
58.3.13 Monitoring and Maintainance of RIP
With the RIP monitored and maintained, the Network Statistics can be displayed, such as: RIP protocol
Parameter Configuration, Network utilization, Real-time Tracing of Network Communication and so on. Such
information can help you judge the use of Network Resource and further solve the network problems and know
the reachability of network nodes .
The following commands can be used to display the statistics information of all kinds of routes under
management statistics:
Command Purpose
show ip rip
Display the present Status of RIP
show ip rip
database Display all routes of RIP
Show ip rip protocol
Display all the relevant information of RIP Protocol
Under the management mode, the following commands shall be used to trace route protocol information.
Command Purpose
Debug ip rip database
Trace the procedure information of RIP Routing such
as Insertion into the Routing Table, Deletion from the
Routing Table, Changes of Routes and so on.
Debug ip rip protocol
Trace the RIP protocol messages.
58.4 Example of the RIP Configuration
Examples of the RIP Configuration is included in this section: