User's Manual

314
intf-name: Stands for the name of an interface.
Switch_config_intf#
ether-ring
id
{primary-port |
secondary-port | transit-port }
Configures the type of the port of Ethernet ring.
ID of the node of Ethernet ring
Switch_config_intf
#exit
Exits from interface configuration mode.
Remark:
The no ether-ring id primary-port { secondary-port | transit-port } command can be used to cancel the port
settings of Ethernet ring.
41.9.4 Browsing the State of the Ring Protection Protocol
Run the following commands to browse the state of the ring protection protocol:
Command Purpose
show ether-ring
id Browses the summary information about the ring
protection protocol and the port of Ethernet ring.
id: ID of Ethernet ring
show ether-ring
id
detail
Browses the detailed information about the ring
protection protocol and the port of Ethernet ring.
show ether-ring
id
interface
intf-name Browses the state of the Ether-ring port or that of
the common port.
41.10 MEAPS Configuration
41.10.1 Configuration Example
MEAPS configuration
As shown in figure 2.1, master node S1 and transit node S2 are configured as follows. As to the settings of
other nodes, they are the same as S2's settings.
Configuring switch S1: