User's Manual

303

TLV Configuration
Configuring switch S1:
Switch_config#lldp run
Switch_config#
Configuring switch S2:
Switch_config#lldp run
Switch_config# no lldp tlv-select system-name
Switch_config#int g0/8
Switch_config_g0/8#no lldp dot1-tlv-select port-vlan-id
Switch_config_g0/8#no lldp dot3-tlv-select max-frame-size
Switch_config_g0/8#
The information of Neighbor B will be displayed on Switch A about 1 minute later, which is highlighted in
red. To differentiate, the information displayed in the basic configuration of 1.4.3.1 is highlighted in blue.
S1:
Switch_config#show lldp neighbors
Capability Codes:
(R)Router,(B)Bridge,(C)DOCSIS Cable Device,(T)Telephone
(W)WLAN Access Point, (P)Repeater,(S)Station,(O)Other
Device-ID Local-Intf Hldtme Port-ID Capability
Switch Gas0/8 92 Gig0/1 R B
Total entries displayed: 1
Switch_config#show lldp neighbors detail
chassis id: 00e0.0fac.32ff
port id: Gig0/1
port description: GigaEthernet0/1
system name: -- not advertised
system description: SWITCH Software, Version 4.1.0B
Serial: S24090103
Compiled: 2011-9-21 9:24:8 by WRL
Time remaining: 95
system capabilities: R B
enabled capabilities: B
Management Address: