User's Manual

300
Command Purpose
Show lldp errors
Displays the error information about the LLDP
module.
Show lldp interface interface-name Displays the information about port state, that is,
the transmission mode and the reception mode.
Show lldp neighbors Displays the abstract information about the
neighbor.
Show lldp neighbors detail Displays the detailed information about the
neighbor.
Show lldp traffic Displays all received and transmitted statistics
information.
Show location elin Displays the information of location elin.
Show location civic Displays the information of location civic.
40.4.13 Configuring the Delete Commands
You can delete the received neighbor lists and all statistics information by running the following commands.
Run the following commands in EXEC mode:
Command Purpose
clear lldp counters Deletes all statistics data.
clear lldp table Deletes all received neighbor information.
40.5 Configuration Example
40.5.1 Network Environment Requirements
Configure LLDP protocol on the port connecting two switches.
40.5.2 Network Topology
Figure 2 Network Topology
40.5.3 Configuration Procedure