User's Manual

296
specifies the address.
a) coordinate-based LCI, which is defined in
IETF 3825[6];
b) city's address LCI, which is defined in IETF
(refer to Annex B);
c) ELIN code of the urgency call service;
Step 12 no lldp med-tlv-select power-
management
(Optional) Sends the MED-defined TLV and
shows the information of power supply.
Step 13 no lldp med-tlv-select inventory (Optional) Sends the MED-defined TLV and
shows the attribute of detailed inventory.
40.4.7 Configuring the Transmission or Reception Mode
LLDP can work under three modes: transmit-only, receive-only and transmit-and-receive. By default, LLDP
works under the transmit-and-receive mode. You can modify the working mode of LLDP through the following
commands.
Run the following commands in the interface configuration mode and set lldp to the transmit-and-receive
mode.
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 interface intf-type intf-id Enters the interface configuration mode.
Step 3 no lldp transmit Disables the transmit-only mode of the port.
Step 4 no lldp receive Disables the receive-only mode of the port.
Run the following commands in the interface configuration mode and set lldp to the transmit-and-receive
mode.
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 interface intf-type intf-id Enters the interface configuration mode.
Step 3 lldp transmit Enables the transmit mode of the port.
Step 4 lldp receive Enables the receive mode of the port.
Note: Besides the above mode, the interface can also be configured to the transmit-only mode or the
receive-only mode.
40.4.8 Specifying the Management IP Address of a Port
In port configuration state, you can randomly configure the management address of the port, from which
the LLDP packets are transmitted. This management address should be an IP address related with this port,
and only in this way the normal communication of this port can be guaranteed.
Run the following commands in port configuration mode to set the management IP address:
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 interface intf-type intf-id Enters the interface configuration mode.