User's Manual

295
Step 9 lldp dot3-tlv-select max-frame-size (Optional) Sends the 802.3-defined TLV and
specifies the size of the maximum frame on a
port(byte) .
Step10 lldp med-tlv-select network-policy (Optional) Sends the MED-defined TLV and the
interface can effectively discover and diagnose
VLAN configured error-matching flow and the
attribute of Layer 2 and Layer 3
Step 11 lldp med-tlv-select location (Optional) Sends the MED-defined TLV and
specifies the address.
a) coordinate-based LCI, which is defined in
IETF 3825[6];
b) city's address LCI, which is defined in IETF
(refer to Annex B);
c) ELIN code of the urgency call service;
Step 12 lldp med-tlv-select power-
management
(Optional) Sends the MED-defined TLV and
shows the information of power supply.
Step 13 lldp med-tlv-select inventory (Optional) Sends the MED-defined TLV and
shows the attribute of detailed inventory.
Run the following commands in global configuration mode to delete to-be-sent TLV:
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 interface intf-type intf-id Enters the interface configuration mode.
Step 3 no lldp dot1-tlv-select port-vlan-id (Optional) Sends the 802.1-defined TLV and
notifies the PVID of a port.
Step 4 no lldp dot1-tlv-select protocol-vlan-id (Optional) Sends the 802.1-defined TLV and
notifies the PPVID of a port.
Step 5 no lldp dot1-tlv-select vlan-name (Optional) Sends the 802.1-defined TLV and
notifies the VLAN name of a port.
Step 6 no lldp dot3-tlv-select macphy-confg (Optional) Sends the 802.3-defined TLV. The
following contents are contained:
a) The bit rate and the communication mode
(duplex) on the physical layer;
b) Current duplex and the set bit rate;
c) Showing whether the setting is the results
of auto-negotiation in the initial connection
phase or is a compulsory manual behavior;
Step 7 no lldp dot3-tlv-select power (Optional) Sends the 802.3-defined TLV and
shows the interface allows the power supply
connecting to the non-power system through
the link.
Step 8 no lldp dot3-tlv-select link-aggregation (Optional) Sends the 802.3-defined TLV and
specifies a port to identify the aggregation if the
link can be aggregated.
Step 9 no lldp dot3-tlv-select max-frame-size (Optional) Sends the 802.3-defined TLV and
specifies the size of the maximum frame on a
port(byte) .
Step 10 no lldp med-tlv-select network-policy (Optional) Sends the MED-defined TLV and the
interface can effectively discover and diagnose
VLAN configured error-matching flow and the
attribute of layer-2 and layer-3.
Step 11 no lldp med-tlv-select location (Optional) Sends the MED-defined TLV and