User's Manual

293
transmit message. The value ranges from 2 to
5. The default time is 2 seconds.
Resumes the default value of reinit.
Procedu
re
Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 no lldp reinit Resumes the default interval of continuously
transmitting message; the default interval
value is two seconds.
40.4.5 Configuring the To-Be-Sent TLV
You can choose TLV which requires to be sent by configuring tlv-select of LLDP. By default, all TLVs are
transmitted.
Run the following commands in global configuration mode to add or delete tlv of LLDP:
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 lldp tlv-select management-address This step is optional. Transmits the
management address tlv. The management
address is usually Layer 3 IP address which
should be easy to use.
Step 3 lldp tlv-select port-description This step is optional. Transmits the port
description tlv. The port description uses
number or letters for description.
Step4 lldp tlv-select system-capabilities This step is optional. Transmits the system
performance tlv. The system performance
refers to the system of transmitting packets
such as the switch or router.
Step 5 lldp tlv-select system-description This step is optional. Transmits system
description tlv. The system description
consists of texts including numbers and letters.
The system description should include the full
name of the system, the hardware version, the
software system and the network software.
Step 6 lldp tlv-select system-name This step is optional. Transmits system name
tlv. The system name domain is a specified
name consisting of numbers and letters. The
name of the system should be the name of the
system manager. That is the name of the
switch.
Run the following commands in global configuration mode to delete to-be-sent TLV:
Procedure Command Purpose
Step 1 config Enters the global configuration mode.
Step 2 no lldp tlv-select management-address This step is optional. Transmits the
management address tlv. The management
address is usually Layer 3 IP address which
should be easy to use.
Step 3 no lldp tlv-select port-description This step is optional. Transmits the port