User's Manual
285
Command Description
aggregator-group load-balance
Configures load balance method.
Note:
The command is unavailable at the switch that does not support load balance methods or supports
only one method. The switch using the command only selects the load balance strategies
supported by itself.
The following table shows different switches spport different kinds of load balance strategies:
Model src-mac dst-mac both-mac src-ip dst-ip both-ip
S2008, S2116,
S2026B
x x x x x x
S2224D
√ √ √ x x x
S2224M, S2226,
S2448
√ √ √ √ √ √
S2516, S2524,
S2524GX
√ √ x x x √
S2448B,S2226C
√ √ √ x x x
S3224, S3224M
S3424, S3448
S3512
√ √ √ √ √ √
S6508
√ x x x x x
S8500
√ √ √ √ √ √
38.3.4 Monitoring the Concrete Conditions of Port Aggregation
Use the following command to monitor port aggregation state in EXEC mode:
Command Description
show aggregator-group
Displays port aggregation state.