User's Manual

195
Set the time interval of port scan
To set the scan interval of an interface, run the following command in the global configuration mode:
Command Purpose
[no] Link scan {mode
highspeed | normal interval |
fast interval }
Mode: optical port scan mode
Normal: standard link scan mode
Fast link scan mode. Fast mode is mainly used for service
protocol requirement, such as rstp.
interval: Set the time interval of port scan.
link scan normal time Sets the time interval of port scan.
25.12.3 Configuration Example
The following example shows how to set the scan interval to 20ms.
link scan normal 20
25.13 Configuring system mtu
25.13.1 Overview
This is used to configure system mtu.
25.13.2 Configuration Task
Set system mtu.