Manualshelf

User's Manual

ManualsBrandsPLANET Technology ManualsLAN SwitchesLayer 3 48-Port 10G SFP+ + 2-Port 40G QSFP+ + 4-Port 100G QSFP28 Managed Switch
191192193194195196197198199200
194
exit Exit to management
configuration mode
25.11 Port FEC
To reduce error rate of 100G port using dual-mode optical module, enable FEC. The function runs with
enabled ports on both sides. Disable this function when using the single-mode optical module.
To enter the configuration mode, run the following mode:
Command Purpose
config Enters the global configuration
mode.
interface cg0/1 Enters the port to be
configured.
[no] fec-enable Configures port FEC.
exit Exit from the global
configuration mode.
exit Exit from the management
configuration mode.
25.12 Configuring Link scan
25.12.1 Overview
The command is used to scan the time interval on the port. You can fast scan the up/down state on the port.
25.12.2 Link Scan Configuration Task
Configure the time interval on the port.