User's Manual

179
20.4 Resuming Initial Configuration
If you click System Manage -> Resume Config, the Resuming the original configuration page appears.
Figure 9 Resuming the original configuration
Note:
1. If you click the “Resume” button, the current configuration will be replaced by the original
configuration, which will take effect after rebooting.
2. Before rebooting the device still works under the current configuration, and if you click “Save
All” at the moment, the current configuration will replace the original configuration. The original
configuration, therefore, cannot take effect after rebooting.
3. After the rebooting is done and the original configuration takes effect, the Web access of the
device will be automatically started. The address of Vlan 1 is 192.168.0.1/255.255.255.0, and
the username and password are both “admin”.
To resume the original configuration, click “Resume” and then reboot the device.
20.5 Rebooting the Device
If you click System Manage -> Reboot Device, the Rebooting page appears.
Figure 10 Rebooting the device
If the device need be rebooted, please first make sure that the modified configuration of the device has already
been saved, and then click the “Reboot” button.