User's Manual
156
15.19 Ring Protection Configuration
15.19.1 EAPS Ring List
If you click Layer-2 Config -> Ring protection Config, the EAPS ring list page appears.
Figure 19 EAPS Ring List
In the list shows the currently configured EAPS ring, including the status of the ring, the forwarding status of
the port and the status of the link.
Click “New” to create a new EAPS ring.
Click the “Operate” option to configure the “Time” parameter of the ring.
Note:
1. The system can support 8 EAPS rings.
2. After a ring is configured, its port, node type and control Vlan cannot be modified. If the port
of the ring, the node type or the control Vlan need be adjusted, please delete the ring and then
establish a new one.
15.19.2 EAPS Ring Configuration
If you click “New” on the EAPS ring list, or “Operate” on the right side of a ring item, the “Configure EAPS”
page appears.
Figure 20 EAPS ring configuration
Note:
If you want to modify a ring, on this page the node type, the control VLAN, the primary port and
the secondary port cannot be modified.
In the dropdown box on the right of “Ring ID”, select an ID as a ring ID. The ring IDs of all devices on the same
ring must be the same.
The dropdown box on the right of “Node Type” is used to select the type of the node. Please note that only one
master node can be configured on a ring.