User's Manual

152
After the PDP port is configured, you can enable or disable PDP on this port.
15.16 STP Configuration
15.16.1 STP Status Information
If you click Layer-2 Config -> STP Config in the navigation bar, the STP Config page appears, as shown in
figure 10.
Figure 10 Configuring the global attributes of STP
The root STP configuration information and the STP port’s status are only-read.
On the local STP configuration page, you can modify the running STP mode by clicking the Protocol type
dropdown box. The STP modes include STP, RSTP and disabled STP.
The priority and the time need be configured for different modes.
Note:
The change of the STP mode may lead to the interruption of the network.
15.16.2 Configuring the Attributes of the STP Port
If you click the "Configure RSTP Port" option, the “Configure RSTP Port” page appears.
Figure 11 Configuring the attributes of RSTP