User's Manual

145
An aggregation group is selectable when it is created but is not selectable when it is modified.
When a member port exists on the aggregation port, you can choose the aggregation mode to be Static,
LACP Active or LACP Passive.
You can click >> and << to delete and add a member port in the aggregation group.
15.9.2 Configuring Load Balance of Port Aggregation Group
Some models support aggregation group based load balance mode configuration and some not but can
be configured in the global configuration mode.
The user can adopt varied aggregation modes for different aggregation groups.
15.10 EAPS Ring Protection Configuration
15.10.1 EAPS Ring List
If you click Layer-2 Config -> Ring Protection ->EAPS Config, the EAPS Ring Config page appears.
In the list shows the currently configured EAPS ring, including the status of the ring, the forwarding status of
the port and the status of the link.
Click “New” to create a new EAPS ring.
Click the “Operate” option to configure the “Time” parameter of the ring.
Note:
1. The system can support 8 EAPS rings.