User's Manual
144
15.7.2 LLDP Port Attribute Configuration
If you click Layer-2 Config -> LLDP Config -> LLDP Interface Config in the navigation bar, the LLDP
Port Config page appears.
Figure 12 Configuring the LLDP port
After the LLDP port is configured, you can enable or disable LLDP on this port.
15.8 DDM Configuration
If you click L2 Config -> DDM Config in the navigation bar, the DDM configuration page appears, as shown
in figure 5-21.
Figure 5-21: DDM configuration
15.9 Link Aggregation Configuration
15.9.1 Port Aggregation Configuration
If you click Advanced Config -> Link aggregation Config in the navigation bar, the Link aggregation Config
page appears, as shown in figure 22.
If you click New, an aggregation group can be created. Up to 32 aggregation groups can be configured
through Web and up to 8 physical ports in each group can be aggregated. If you click Cancel, you can delete
a selected aggregation group; if you click Modify, you can modify the member port and the aggregation mode.