Manualshelf

User's Manual

ManualsBrandsPLANET Technology ManualsLAN SwitchesLayer 3 48-Port 10G SFP+ + 2-Port 40G QSFP+ + 4-Port 100G QSFP28 Managed Switch
141142143144145146147148149150
143
Click Delete to delete the selected MAC address table.
Figure 19 Static MAC Address Config
15.7 LLDP Configuration
15.7.1 Configuring the Global Attributes of LLDP
If you click Layer-2 Config -> LLDP Config -> LLDP Global Config in the navigation bar, the Basic
Config of LLDP Protocol page appears, as shown in the following Figure.
Figure11 Configuring the Global Attributes of LLDP
You can choose to enable LLDP or disable it. When you choose to disable LLDP, you cannot configure
LLDP.
The “HoldTime” parameter means the ttl value of the packet that is transmitted by LLDP. Its default value
is 120s.
The “Reinit” parameter means the delay of successive packet transmission of LLDP. Its default value is
2s.