User's Manual

131
Click the dropdown list on the right side of "Mirror Port" and select a port to be the destination port of mirror.
Click a checkbox and select a source port of mirror, that is, a mirrored port.
14.5 Loopback Detection
If you click Physical port Config -> Port loopback detection in the navigation bar, the Setting the port
loopback detection page appears, as shown in figure 4-6.
Figure 4-6: Port loopback detection
You can set the loopback detection cycle on the Loopback Detection page.
14.6 Port security
14.6.1 IP Binding Configuration
If you click Physical port Config -> Port Security -> IP bind in the navigation bar, the Configure the IP-
Binding Info page appears, as shown in figure 4-7.
Figure 4-7 IP binding configuration
Click “Detail” and then you can conduct the binding of the source IP address for each physical port. In this way,
the IP address that is allowed to visit the port will be limited.
Figure 4-8 Setting the binding of the source IP address
14.6.2 MAC Binding Configuration
If you click Physical port Config -> Port Security -> MAC bind in the navigation bar, the Configure the
MAC-Binding Info page appears, as shown in figure 4-10.
Figure 4-9 MAC binding configuration
Click “Detail” and then you can conduct the binding of the source MAC address for each physical port. In this
RX The received packets will be mirrored to the destination port.
TX The transmitted packets will be mirrored to a destination port.
RX & TX The received and transmitted packets will be mirrored simultaneously.