User Manual

42
Users Manual of XGS-6350-24X4C
Figure3-7 Run telnet client program included in Windows
Step 3: Log in to the switch.
Log in to the Telnet configuration interface. Valid login name and password are required, otherwise, the switch
will reject Telnet access. This is the method to protect the switch from unauthorized access.
Enter valid login name and password in the Telnet configuration interface, Telnet user will be able to enter the
switch’s CLI configuration interface. The commands used in the Telnet CLI interface after login is the same as
that in the console interface.
Figure3-8 Telnet Configuration Interface
3.1.2.2 Management via HTTP
To manage the switch via HTTP, the following conditions should be met:
1) Switch has an IPv4/IPv6 address configured;
2) The host IPv4/IPv6 address (HTTP client) and the switch’s VLAN interface IPv4/IPv6 address are in
the same network segment;