User Manual

409
Users Manual of XGS-6350-24X4C
timers holddown value
It means how much time is needed for a route to
be deleted from the routing table.
timers expirevalue
It means what interval is needed for a route to be
declared ineffective.
timers updatevalue
It means the transmission frequency of the
routing update information.
45.1.3.5 Specifying the RIP Version Number
The RIP-2 of our switches supports authentication, PIN management, routing summary, CIDR and VLSM. By
default, the switch receives RIP-1 and RIP-2, but the switch only sends RIP-1. Through configuration, the
switch can receive and send only the packet RIP-1, or only the packet RIP-2. To meet the previous demand,
run the following command in switch configuration mode:
Command Purpose
version {1 | 2}
The switch sends and receives only RIP-1 or only
RIP-2.
The previous tasks control the default actions of the RIP. You also can configure a certain interface to change
the default actions.
Run the following commands in VLAN configuration mode to control the interface whether to send RIP-1 or
RIP-2.
Command Purpose
ip rip send version 1
The configured interface only sends RIP-1.
ip rip send version 2
The configured interface only sends RIP-2.
ip rip send
versioncompatibility
Sends the RIP-2 update message in the form of
broadcast.
Run the following commands in interface configuration mode to control the interface whether to receive
packet RIP-1 or packet RIP-2
Command Purpose
ip rip receive version 1
The configured interface only receives RIP-1.
ip rip receive version 2
The configured interface only receives RIP-2.
ip rip receive version 1 2
The configured interface receives RIP-1 and
RIP-2.
45.1.3.6 Activating RIP Authentication
RIP-1 does not support authentication. To receive and send the RIP-2 packet, you can activate the RIP
authentication on the interface.
On the activated interface, two authentication modes are provided: plain text authentication and MD5