User Manual

390
Users Manual of XGS-6350-24X4C
ip dhcp client select seconds
Specify the interval for SELECT.
The command is optional when you perform operations to obtain an IP address.
4. Monitoring DHCP
To check information about DHCP-server currently found by switch, run the following command in
management mode:
Run... To...
show dhcp server
Display information about the DHCP
server known by the routing switch.
Run the following command in management mode to check the IP address currently used by the routing
switch:
Run... To...
show dhcp lease
Display the IP address resources
currently used by the routing switch
and relevant information.
Additionally, if the DHCP protocol is used to distribute an IP address for an Ethernet interface, you can run
show interface to check whether the IP address required by the Ethernet interface is successfully obtained.
43.3.2.3 DHCP Client Configuration Example
Obtaining an IP address
The following example shows Ethernet1/1 obtains an IP address through DHCP.
!
interface vlan 11
ip address dhcp
43.3.3 Configuring DHCP Server
43.3.3.1 DHCP Server Configuration Tasks
 Enabling DHCP server
 Disabling DHCP server
 Configuring ICMP detection parameter
 Configuring database storage parameter
 Configuring the address pool of DHCP server
 Configuring the parameter for the address pool of DHCP server
 Monitoring DHCP server
 Clearing information about DHCP server