User Manual
276
Users Manual of XGS-6350-24X4C
create the sub-ring edge node or sub-ring assistant node, prompt information will appear (in this case,
you can use the show command to browse the MEAPS state; if you find the basic information is
complete but the state is init, it indicates that the configuration of the ring’s node has not finished).
Conflicts arising during control VLAN configuration: If the control VLAN, which is configured by a node,
conflicts with other configured nodes, prompt information will appear (in this case, you can use the show
command to browse the MEAPS state; if you find the basic information is complete but the state is init, it
indicates that the configuration of the ring’s node has not finished).
If a sub-ring node corresponding to a major-ring node is configured, the ID of the sub-ring node must be
bigger than that of the major-ring node; if the sub-ring node’s ID is less than the major-ring node’s ID, the
sub-ring node cannot be created and related prompt information pops out.