User Manual
246
Users Manual of XGS-6350-24X4C
26.2.4.4 Browsing the State of the Ring Protection Protocol
Run the following command to browse the state of the ring protection protocol:
Command Purpose
show ether-ring id
Browses the summary information about the
ring protection protocol and the port of Ethernet
ring.
id: ID of Ethernet ring
show ether-ring id detail
Browses the detailed information about the ring
protection protocol and the port of Ethernet
ring.
show ether-ring id interface intf-name
Browses the state of the Ether-ring port or that
of the common port.
26.2.5 MEAPS configuration
26.2.5.1 Configuration Example
MEAPS configuration
As shown in figure 2.1, master node S1 and transit node S2 are configured as follows. As to the settings of
other nodes, they are same to S2's settings.
Configuring switch S1:
Shuts down STP and configures the Ether-ring node:
S1_config#no spanning-tree
S1_config#ether-ring 1
S1_config_ring1#control-vlan 2
S1_config_ring1#master-node