User Manual

244
Users Manual of XGS-6350-24X4C
triggered.
 The physical interface, the fast-Ethernet interface, the gigabit-Ethernet interface and the aggregation
interface can all be set to be the ring's interfaces. If link aggregation, 802.1X or port security has been
already configured on a physical interface, the physical interface cannot be set to be a ring’s interface
any more.
The versions of switch software prior to version 2.0.1L and the versions of hi-end
switch software prior to version 4.0.0M do not support the configuration of the
converged port.
26.2.3 MEAPS Configuration Tasks
 Configuring the Master Node
 Configuring the Transit Node
 Configuring the Ring Port
 Browsing the State of the Ring Protection Protocol
26.2.4 Fast Ethernet Ring Protection Configuration
26.2.4.1 Configuring the Master Node
Configure a switch to be the master node of a ring network according to the following steps:
Command Purpose
Switch#config Enters the switch configuration mode.
Switch_config#ether-ring id
Sets a node and enters the node
configuration mode.
id: Instance ID
Switch_config_ring#control-vlan vlan-id
Configures the control VLAN.
Vlan-id: ID of the control VLAN
Switch_config_ring#master-node Configures the node type to be a master
node.
Switch_config_ring#hello-time value
This step is optional. Configures the cycle
for the master node to transmit the HEALTH
packets.
Value: It is a time value ranging from 1 to 10
seconds and the default value is 1 second.
Switch_config_ring#fail-time value
This step is optional. Configures the time for
the secondary port to wait for the HEALTH
packets.
Value: It is a time value ranging from 3 to 30
seconds and the default value is 3 second.
Switch_config_ring#exit Saves the current settings and exits the