User Manual

166
Users Manual of XGS-6350-24X4C
Run the following command in interface configuration command to set the maximum times for ID
authentication request:
Run… To
dot1x max-req count
Set the maximum times for ID
authentication request.
15.2.4 Configuring 802.1x Re-authentication
After first authentication is approved, the client will be authenticated every a certain time to ensure the legality
of the client. In this case, the re-authentication function needs to be enabled.
After the re-authentication function is enabled, 802.1x will periodically send the authentication request to the
host.
You can run the following commands to configure the re-authentication function.
Run… To…
dot1x re-authentication
Enable the re-authentication function.
dot1x timeout re-authperiod time
Configure the period of
re-authentication.
dot1x reauth-max time
Configure the retry times after the
re-authentication fails.
15.2.5 Configuring 802.1x Transmission Frequency
In the process of 802.1x authentication, data texts will be sent to the host. The data transmission can be
adjusted by controlling 802.1x transmission frequency so that the host response is successful.
Run the following command to configure the transmission frequency:
Run… To…
dot1x timeout tx-period time
Set the message transmission
frequency of 802.1x.
15.2.6 Configuring 802.1x User Binding
When 802.1x authentication is performed, you can bind a user to a certain port to ensure the security of port
access. Run the following command in interface configuration mode to start up 802.1x user binding.
Run… To…
dot1x user-permitxxxz
Configure a user that is bound to a
port.
15.2.7 Configuring Authentication Method for 802.1x Port
The 802.1x authentication can be performed in different methods at different ports. In the default configuration,
the 802.1x authentication adopts the default method.
Run the following command in interface configuration mode to configure the method of the 802.1x