User Manual

149
Users Manual of XGS-6350-24X4C
The bandwidth is just a routing parameter, which doesn’t influence the communication rate of the actual
physical interface.
8.2.1.3 Configuring Time Delay
The upper protocol uses time delay information to perform operation decision. Use the following command to
configure time delay for the interface in the interface configuration mode.
Command Description
delaytensofmicroseconds
Configures time delay for the currently
configured interface.
The configuration of time delay is just an information parameter. Use this command cannnot adjust the actual
time delay of an interface.
8.2.2 Monitoring and Maintaining Interface
The following tasks can monitor and maintain interface:
 Checking interface state
 Initializing and deleting interface
 Shutting down and enabling interface
8.2.2.1 Checking Interface State
Our switch supports displaying several commands related to interface information, including version number
of software and hardware, interface state. The following table lists a portion of interface monitor commands.
For the description of these commands, please refer to ‘Interface configuration command’.
Use the following commands:
Command Description
show interface [type [slot|port]] Displays interface state.
show running-config Displays current configuration.
8.2.2.2 Initializing and Deleting Interface
You can dynamically establish and delete logical interfaces. This also applies to the sub interface and
channalized interface. Use the following command to initialize and delete interface in global configuration
mode:
Command Description
no interface type [slot|port]
Initializes physical interface or deletes virtual
interface.
8.2.2.3 Shutting down and Enabling Interface
When an interface is shut down, all features of this interface are disabled, and also this interface is marked as
unavailable interface in all monitor command displays. This information can be transmitted to other switches