User Manual

128
Users Manual of XGS-6350-24X4C
Enter a value between 1 and 4094 in the text box on the right of “Control VLAN” as the control VLAN ID.
When a ring is established, the control VLAN will be automatically established too. Please note that if the
designated control VLAN is 1 and the VLAN of the control device is also 1 the control device cannot access
the control VLAN. Additionally, please do not enter a control VLAN ID that is same as that of another ring.
In the text boxes of “Primary Port” and “Secondary Port”, select a port as the ring port respectively. If "Node
Type" is selected as “Transit-Node”, the two ports will be automatically set to transit ports.
Click “Apply” to finish EAPS ring configuration, click “Reset” to resume the initial values of the configuration, or
click “Return” to go back to the EAPS list page.
7.5.9 DDM Configuration
If you click L2 Config -> DDM Config in the navigation bar, the DDM configuration page appears, as shown
in figure 21.
Figure 21: DDM configuration
Layer 3 Configuration
7.6
Figure 1: Layer-3 configuration list
Only layer-3 switches have the layer-3 configuration.