User Manual

122
Users Manual of XGS-6350-24X4C
The “HoldTime” parameter means the ttl value of the packet that is transmitted by LLDP, whose default value
is 120s.
The “Reinit” parameter means the delay of successive packet transmission of LLDP, whose default value is
2s.
7.5.3.2 Configuring the Attributes of the LLDP Port
If you click Layer 2 Config -> LLDPConfig-> LLDP port Config in the navigation bar, the Setting the attributes
of the LLDP port page appears, as shown in figure 7.
Figure 7: Configuring the LLDP port
After the LLDP port is configured, you can enable or disable LLDP on this port.
7.5.4 Link Aggregation Configuration
If you click Layer 2 Config ->Port Channel in the navigation bar, the Port aggregation Config page appears,
as shown in figure 8.
Figure 8: Port aggregation configuration
If you click New, an aggregation group can be created. Up to 32 aggregation groups can be configured
through Web and up to 8 physical ports in each group can be aggregated. If you click Cancel, you can delete
a selected aggregation group; if you click Modify, you can modify the member port and the aggregation
mode.
Figure 9: Setting the member port of the aggregation group