User Manual

121
Users Manual of XGS-6350-24X4C
Figure 4: Configuring the global attributes of PDP
You can choose to enable PDP or disable it. When you choose to disable PDP, you cannot configure PDP.
The “HoldTime” parameter means the time to be saved before the router discards the received information if
other PDP packets are not received.
The protocol version cannot be read currently through the command line “show run”, so the protocol version is
not handled on the Web.
7.5.2.2 Configuring the Attributes of the PDP Port
If you click Layer 2 Config -> PDPConfig-> PDP port Config in the navigation bar, the Setting the attributes of
the PDP port page appears, as shown in figure 5.
Figure 5: PDP port configuration
After the PDP port is configured, you can enble or disable PDP on this port.
7.5.3 LDP Configuration
7.5.3.1 Configuring the Global Attributes of LLDP
If you click Layer 2 Config -> LLDP Config in the navigation bar, the Global LLDP Config page appears, as
shown in figure 6.
Figure 6: Configuring the global attributes of LLDP
You can choose to enable LLDP or disable it. When you choose to disable LLDP, you cannot configure LLDP.