Datasheet
XGS-6350-24X4C
1
Powerful 100Gbps Solution for All Long-Reach Networks
PLANET XGS-6350-24X4C is a high performance Layer 3 Managed Switch that
meets the next generation Metro, Data Center, Campus and Enterprise network
requirements. It has high-density 24 10G SFP+ and 4 40G/100GbE QSFP28 ber
interfaces delivered in a 1RU rugged case.
The XGS-6350-24X4C comes with the complete Layer 3 managed function with
comprehensive protocols and applications to facilitate the rapid service deployment
and management for both the traditional L2 and L3 networks. With support for
advanced features, including RIP, OSPF, BGP, PIM-DM/SM, etc., this switch is
ideal for the traditional or fully virtualized data center.
The administrator can flexibly choose the suitable transceivers according to
the transmission distance or the transmission speed required extending the
1G/10G/40G/100G network efficiently. Besides, with 800Gbps switching capacity,
the XGS-6350-24X4C can handle extremely large amounts of data in a secure
topology linking to backbone or high capacity servers where audio, video
streaming and multicast applications are utilized.
Extractive Power Supply Design to Increase Flexibilty
The XGS-6350-24X4C is equipped with one extractive 100~240V AC power supply
unit, so it is easy to replace the power for users. Besides, the XGS-6350-24X4C
reserves another backup power slot on the rear panel and users can add the
second AC or DC power to the redundant power supply installation. The AC power
or DC power is optional. The redundant power system is specifically designed to
handle the demands of high-tech facilities requiring the highest power integrity.
Layer 3 24-Port 10G SFP+ + 4-Port 100G QSFP28
Managed Switch
Physical Ports
• 24 10GBASE-SR/LR SFP+ slots, compatible with
1000BASE-SX/LX/BX SFP
• 4 QSFP28 slots, each supports native 100 Gigabit
Ethernet, 40G and 4 x 10 Gigabit Ethernet modes
• RJ45 to DB9 console interface for switch basic
management and setup
IP Routing Features
• Supports maximum 128 static routes and route
summarization
• Supports dynamic routing protocol: RIP and OSPF
Layer 2 Features
• Auto-MDI/MDI-X detection on each RJ45 port
• Prevents packet loss ow control
–
IEEE 802.3x pause frame ow control in full-duplex
mode
–
Back-pressure ow control in half-duplex mode
• High performance Store-and-Forward architecture,
broadcast storm control, port loopback detect
• 32KC MAC address table, automatic source address
learning and aging
• Supports VLAN
–
IEEE 802.1Q tag-based VLAN
–
GVRP for dynamic VLAN management
–
Up to 4094 active VLANs
–
Provider Bridging (VLAN Q-in-Q, IEEE 802.1ad)
supported
–
Private VLAN Edge (PVE) supported
–
GVRP protocol for Management VLAN
–
Protocol-based VLAN
–
MAC-based VLAN
• Supports Link Aggregation
–
Maximum 32 trunk groups with up to 8 ports per trunk
group
–
IEEE 802.3ad LACP (Link Aggregation Control Protocol)
–
Cisco ether-channel (static trunk)
• Supports Spanning Tree Protocol
–
STP, IEEE 802.1D (Classic Spanning Tree Protocol)
–
RSTP, IEEE 802.1w (Rapid Spanning Tree Protocol)