User's Manual

– 1 – – 2 –
– 3 – – 4 –
1. Overview
Thank you for purchasing PLANET 150-watt AC power supply.
Power Supply Unit Input Range
XGS-PWR150-AC 100 to 240V AC
Open the box of the Redundant Power Supply unit and carefully
unpack it. The box should contain the following items:
 The AC Power Supply unit x 1
 User’s Manual x 1
If any item is found missing or damaged, please contact your local
reseller for replacement.
2. Introduction
Before installation, please be sure to read this user’s manual
carefully to successfully complete the correct installation of the
XGS-PWR150-AC 150-watt AC Power Supply Unit. This manual
shows how to quickly install the power in the XGS-6350-24X4C
Switch.
The following gure shows the front panel of the XGS-PWR150-AC.
Figure 2-1 XGS-PWR150-AC Front View
3. Installing Redundant Power Supply
Unit
Note
The XGS-PWR150-AC is hot-swappable, so there is
no need to power off the switch before removing it
from the switch.
Follow these steps to install the redundant power in the switch:
1. Place the switch on a at surface. Use a screwdriver to unscrew
screws on both sides of the blank plate to remove the blank
plate. Do not discard the blank plate as it can be used again
when removing the power supply unit from the switch.
2
1
1
Figure 3-1 Removing the Blank Plate
2. Install the redundant power by sliding it into the compartment.
1
2
2
Figure 3-2 Sliding the Power Supply Unit into the Compartment
3. Next, tighten the thumbscrews on both sides.
Figure 3-3 Tightening the Thumbscrews.