XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
89
6.3 Examples of Cluster Administration
Scenario:
The four switches SW1-SW4, amongst the SW1 is the command switch and other switches
are member switch. The SW2 and SW4 is directly connected with the command switch, SW3
connects to the command switch through SW2.
Fig 4-1 Examples of Cluster
Configuration Procedure
1. Configure the command switch
Configuration of SW1:
Switch(config)#cluster run
Switch(config)#cluster ip-pool 10.2.3.4
Switch(config)#cluster commander 5526
Switch(config)#cluster auto-add
2. Configure the member switch
Configuration of SW2-SW4
Switch(config)#cluster run
snmp-server enable
Enable snmp server function in
commander switch and member
switch.
Notice: must insure the snmp server
function be enabled in member
switch when commander switch
visiting member switch by snmp. The
commander switch visit member
switch via configure character string
<commander-community>@sw<me
mber id>.
E1 E1 E1 E1 E2 E2
SW1 SW2 SW3 SW4