XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
74-14
Fig 1-9 lacp mad detection topology
As shown in the above picture, use the lacp mad detection function between two vsf. Vsf1 and v
sf2 are the devices which are detected and they are also the middle devices. The configuration is sa
me with above. Proposal: uses create the overlapping connection among the devices to avoid that th
e vsf1 cannot be the middle device to detect vsf2 after it is split.
Assume that vsf1 and vsf2 use the lacp ports of ethernet1/1/1, ethernet 1/1/2, ethernet 2/1/1 and
ethernet 2/1/2.
vsf1 configuration:
Switch(config)#vsf domain 1
Configure vsf domain number, it can be configured as other value but it cannot be the same as
vsf2.
Switch(config)#port-group 1
Switch(config)#interface ethernet 1/1/1
Switch(config-if-ethernet1/1/1)#port-group 1 mode active
Switch(config)#interface ethernet 1/1/2