XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
68-5
The configuration of Switch C is as follows: (Switch A and Switch B may have the
different command because of different companies, we not explain there, our switches
are not support NTP server at present)
Switch C:
Switch(config)#ntp enable
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 192.168.1.12 255.255.255.0
Switch(config)#interface vlan 2
Switch(Config-if-Vlan1)#ip address 192.168.2.12 255.255.255.0
Switch(config)#ntp server 192.168.1.11
Switch(config)#ntp server 192.168.2.11
68.4 NTP Function Troubleshooting
In configuration procedures, if there is error occurred, the system can give out the
debug information.
The NTP function disables by default, the show command can be used to display
current configuration. If the configuration is right please use debug every relative debug
ging command and display specific information in procedure, and the function is configu
red right or not, you can also use show command to display the NTP running informati
on, any questions please send the recorded message to the technical service center.