XGS-5240-Series User Manual

Table Of Contents
Configuration Guide of XGS-5240-Series
59-15
Configuration steps:
Configure the portal server information for switch1.
switch1 (config-cp)#enable
switch1 (config-cp)#configuration 1
switch1 (config-cp-instance)#enable
switch1 (config-cp-instance)# redirect attribute url-after-login enable
switch1 (config-cp-instance)# redirect attribute url-after-login encode plain-text
switch1 (config-cp-instance)# redirect attribute url-after-login name ad
switch1 (config-cp-instance)# redirect attribute url-after-login value http://www.test.com
59.5.4 Automatic Page Pushing after Successful Authentic
ation Troubleshooting
When there is problem in using the automatic page pushing function after the succ
essful authentication, please check the following reasons:
Check if the captive portal authentication function is configured correctly. The auto
matic page pushing function after the successful authentication can be effect when
the captive portal function is normal.
If the command of redirect attribute url-after-login value is configured, the config
ured page url can be pushed automatically after the authentication; if that comman
d is not configured, the page that the user access before the authentication can b
e pushed.
Check if the page before the authentication or the pushed page appointed by com
mand exists, if not, the page cannot be accessed after pushing.
59.6 http-redirect-filter
59.6.1
Introduction to http-redirect-filter
http-redirect-filter appoints the IP or domain name for the HTTP redirection of portal
authentication. Only the HTTP packet configured this IP or domain name can be redir
ected.
This function can be used with Captive Portal, which means to achieve filtering the
user accessing after enabled captive portal.
59.6.2 http-redirect-filter Configuration
http-redirect-filter configuration task list: