XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
59-11
ent1, and the Destination IP is the address segment for client who wants to access the
resources. Appoint RADIUS server 1 as the authentication server, client1 and client2 c
an access the free-resource of 3.1.1.0/24 and will not be redirected to the authenticatio
n server.
Fig 15-3 multi-portal servers function configuration
Configuration steps:
Switch1(config-)# free-resource destination ipv4 3.1.1.0/24
59.3.4 Free-resource Troubleshooting
Encounter problems when using the redirection function, please check whether the
reasons are as follows:
 Whether launched the captive portal function and opened the portal configuration s
witch. Both the captive portal and the portal configuration should be open; otherwis
e, the captive portal function will not work, the client also cannot be redirect to the
specified page.
 Whether the port which connects the client and switch is enabled portal rule.
59.4 Authentication White-list Configuration
59.4.1
Introduction to Authentication White-list
Authentication white-list is used for some special users in the network. The adminis
trator can set permission to allow the users to connect to the network to use network r
esources without authentication, but the administrator needs to get the user’s mac addr
ess. At the same time the user who has the permission to use network resources do n
ot need to billing. So the user belongs to the advanced user.