XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
59-6
switch (config)#radius-server key 0 test
switch (config)#aaa group server radius radius_aaa_1
switch (config-sg-radius)# server 192.168.40.100
The configuration of global authentication:
Switch(config)#interface vlan 1
Switch(config-if-vlan1)#ip address 192.168.40.50 255.255.255.0
Switch(config)#free-resource 1 destination ipv4 192.168.40.99/32
Switch(config)# vlan-pool 1 2-10
Configure the portal function and portal server under the portal instance:
Switch (config)#captive-portal
Switch (config-cp)#enable
Switch(config-cp)# nas-ipv4 192.168.40.50
Switch(config-cp)# external portal-server server-name abc ipv4 192.168.40.99
Switch (config-cp)# configuration 1
Switch (config-cp-instance)#name helix4
Switch (config-cp-instance)#radius-auth-server abc99
Switch (config-cp-instance)# redirect attribute nas-ip enable
Switch (config-cp-instance)#redirect attribute nas-ip name kk
Switch (config-cp-instance)#ac-name helix4
Switch (config-cp-instance)#redirect url-head http://192.168.40.99/a70.htm
Switch (config-cp-instance) # portal-server ipv4 abc
Enable the portal function on the port:
Switch (config)# interface ethernet1/2
Switch (config-if-ethernet1/2)#portal enable configuration 1 vlan-pool 1
59.1.4 Captive Portal Authentication Troubleshooting
Encounter problems when using the redirection function, please check whether the
reasons are as follows:
 Whether launched the captive portal function and opened the portal configuration s
witch. Both the captive portal and the portal configuration should be open; otherwis
e, the captive portal function will not work, the client also cannot be redirect to the
specified page.
 The authentication server name of AAA module is same to the configured authentic
ation name of captive portal.
 Whether the port which connects the pc and switch is enabled portal authentication