XGS-5240-Series User Manual

ManualsBrandsPLANET Technology ManualsLAN SwitchesLayer 2+ 24-Port 10G SFP+ + 2-Port 40G QSFP+ Stackable Managed Switch

451

452

453

454

455

456

457

458

459

460

Table Of Contents

Configuration Guide of XGS-5240-Series

57-8

Both host and BAS server run PPPoE protocol, they are connected by layer 2 eth

ernet, switch enables PPPoE Intermediate Agent function.

Typical configuration (1) in the following:

Step1: Switch enables global PPPoE IA function, MAC as 0a0b0c0d0e0f.

Switch(config)# pppoe intermediate-agent

Step2: Configure port ethernet1/0/1 which connect server as trust port, and configure ve

ndor tag strip function.

Switch(config-if-ethernet1/0/1)#pppoe intermediate-agent trust

Switch(config-if-ethernet1/0/1)#pppoe intermediate-agent vendor-tag strip

Step3: Port ethernet1/0/2 of vlan1 and port ethernet1/0/3 of vlan 1234 enable PPPoE I

A function of port.

Switch(config-if-ethernet1/0/2)#pppoe intermediate-agent

Switch(config-if-ethernet1/0/3)#pppoe intermediate-agent

Step4: Configure pppoe intermediate-agent access-node-id as abcd.

Switch(config)#pppoe intermediate-agent type tr-101 circuit-id access-node-id abcd

Step5: Configure circuit ID as aaaa, remote ID as xyz for port ethernet1/0/3.

Switch(config-if-ethernet1/0/3)#pppoe intermediate-agent circuit-id aaaa

Switch (config-if-ethernet1/0/3)#pppoe intermediate-agent remote-id xyz

circuit-id value is ”abcd eth 01/002:0001”, remote-id value is ”0a0b0c0d0e0f” for the add

ed vendor tag of port ethernet1/0/2.

circuit-id value is ”aaaa”, remote-id value is ”xyz” for the added vendor tag of port ethe

rnet1/0/3.

Typical configuration (2) in the following: