XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
38
10Gbps SFP+ (10G Ethernet/10GBASE)
Model Speed (Mbps)
Connector
Interface
Fiber Mode Distance
Wavelength
(nm)
Operating
Temp.
MTB-SR 10G LC Multi Mode Up to 300m 850nm
0 ~ 60
degrees
C
MTB-LR
10G LC
Single Mode 10km 1310nm
0 ~ 60
degrees
C
10Gbps SFP+ (10GBASE-BX, Single Fiber Bi-directional SFP)
Model
Speed
(Mbps)
Connector
Interface
Fiber Mode Distance
Wave
length
(TX)
Wavelength
(RX)
Operating Temp.
MTB-LA20
MTB-LB20
10G WDM(LC) Single Mode 20km 1270nm 1330nm 0 ~ 60 degrees C
10G
WDM(LC)
Single Mode
20km
1330nm
1270nm
0 ~ 60 degrees C
MTB-LA40
MTB-LB40
10G
WDM(LC)
Single Mode
40km
1270nm
1330nm
0 ~ 60 degrees C
10G
WDM(LC)
Single Mode
40km
1330nm
1270nm
0 ~ 60 degrees C
MTB-LA60
MTB-LB60
10G
WDM(LC)
Single Mode
60km
1270nm
1330nm
0 ~ 60 degrees C
10G
WDM(LC)
Single Mode
60km
1330nm
1270nm
0 ~ 60 degrees C
It is recommended to use PLANET SFP/SFP+ on the Managed
Switch. If you
insert an SFP/SFP+ transceiver that is not supported, the Managed
Switch will
not recognize it.
1. Before we connect the SGS-6341 series to the other network device, we have to make sure
both sides of the SFP transceivers are with the same media type, for example: 1000BASE-SX
to 1000BASE-SX, 1000Bas-LX to 1000BASE-LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver requirement.
 To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with
one side being the male duplex LC connector type.
 To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with
one side being the male duplex LC connector type.
 Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP/SFP+ transceiver.
2. Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3. Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure
that the SFP/SFP+ transceiver is operating correctly.
4. Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or
Media Converters, user has to set the port Link mode to “10G Force”, “1000M Force” or “100M
Force”.