XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
43-7
no ipv6 mld snooping vlan <vlan-i
d> suppression-query-time
Ipv6 mld snooping vlan <vlan-id>
static-group <X:X::X:X> [source <
X:X::X:X>] interface [ethernet | por
t-channel] <IFNAME>
no ipv6 mld snooping vlan <vlan-i
d> static-group <X:X::X:X> [source
<X:X::X:X>] interface [ethernet | p
ort-channel] <IFNAME>
Configure static-group on specified port of the V
LAN. The no form of the command cancels this
configuration.
43.2.3 MLD Snooping Examples
Scenario 1: MLD Snooping Function
Fig 2-2 Open the switch MLD Snooping Function figure
As shown above, the vlan 100 configured on the switch consists of ports 1, 2, 6,
10 and 12. Four hosts are respectively connected to 2, 6, 10 and 12 while the multica
st router on port 1. Suppose we need MLD Snooping on VLAN 100, however by defau
lt, the global MLD Snooping as well as the MLD Snooping on each VLAN are, therefor
e first we have to enable the global MLD Snooping at the same time enable the MLD
Snooping on VLAN 100, furthermore we need to set the port 1 of VLAN 100 as a mro
uter port.
Configuration procedure is as follows.
Switch#config
Switch(config)#ipv6 mld snooping
Switch(config)#ipv6 mld snooping vlan 100
Switch(config)#ipv6 mld snooping vlan 100 mrouter-port interface ethernet 1/0/1
Multicast Router
Mrouter Port
MLD Snooping
Switch
Group1 Group1 Group1 Group2