XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
43-3
2）Configure the maximum response time of MLD query
3）Configure the overtime of MLD query
Command
Explanation
Port Configuration Mode
ipv6 mld query-interval <time_va
l>
no ipv6 mld query-interval
Configure the interval of MLD query messag
es sent periodically; the NO operation of this
command restores the default value.
ipv6 mld query-max-response-tim
e <time_val>
no ipv6 mld query-max-response-
time
Configure the maximum response time of the
interface for MLD query; the NO operation
of this command restores the default value.
ipv6 mld query-timeout <time_va
l>
no ipv6 mld query-timeout
Configure the overtime of the interface for M
LD query; the NO operation of this command
restores the default value.
3. Shut down MLD Protocol
Command
Explanation
Port Configuration Mode
no ipv6 pim dense-mode | no ipv
6 pim sparse-mode | no ipv6 pim
multicast-routing (Global Mode)
Shut down MLD Protocol
43.1.3 MLD Typical Application
As shown in the following figure, add the Ethernet interfaces of Switch A and Swit
ch B to corresponding vlan, and start PIM6 on each vlan interface.
Fig 2-1 Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
SwitchB
Vlan 1
Vlan 1
Vlan 2
Switch
A