XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
43-2
1、 Start MLD (Required)
2、 Configure MLD auxiliary parameters (Required)
（1）Configure MLD group parameters
1）Configure MLD group filter conditions
（2）Configure MLD query parameters
1）Configure the interval of MLD sending query message
2）Configure the maximum response time of MLD query
3）Configure overtime of MLD query
3、 Shut down MLD Protocol
1. Start MLD Protocol
There is no special command for starting MLD Protocol on EDGECORE series lay
er 3 switches. MLD Protocol will automatically start up as long as any IPv6 multicast p
rotocol is started on corresponding interface.
Command
Explanation
Global Mode
Ipv6 pim multicast-routing
To start Global IPv6 Multicast Protocol, the p
recondition of starting MLD Protocol. The NO
operation of corresponding command shuts i
pv6 multicast protocol and MLD Protocol. (R
equired)
Command
Explanation
Port Configuration Mode
ipv6 pim dense-mode | ipv6 pim
sparse-mode
Start MLD Protocol. The NO operation of cor
responding command shuts MLD Protocol. (R
equired)
2. Configure MLD auxiliary parameters
（
1
）
Configure MLD group parameters
1） Configure MLD group filter conditions
Command
Explanation
Port Configuration Mode
ipv6 mld access-group <acl_nam
e>
no ipv6 mld access-group
Configure the filter conditions of interface for
MLD group; the NO operation of this comm
and cancels filter conditions.
（
2
）
Configure MLD Query parameters
1）Configure interval time for MLD to send query messages