XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
42-16
ip igmp snooping vlan <vlan-id> report
source-address <A.B.C.D>
no ip igmp snooping vlan <vlan-id> re
port source-address
Configure forwarding IGMP packet source
address, The no operation cancels the pac
ket source address.
ip igmp snooping vlan <vlan-id> specif
ic-query-mrsp <value>
no ip igmp snooping vlan <vlan-id> sp
ecific-query-mrspt
Configure the maximum query response ti
me of the specific group or source, the no
command restores the default value.
42.3.3 IGMP Snooping Examples
Scenario 1: IGMP Snooping function
Fig 1-2 Enabling IGMP Snooping function
Example: As shown in the above figure, a VLAN 100 is configured in the switch and in
cludes ports 1, 2, 6, 10 and 12. Four hosts are connected to port 2, 6, 10 and 12 res
pectively and the multicast router is connected to port 1. As IGMP Snooping is disable
d by default either in the switch or in the VLANs, If IGMP Snooping should be enabled
in VLAN 100, the IGMP Snooping should be first enabled for the switch in Global Mo
de and in VLAN 100 and set port 1 of VLAN 100 to be the mrouter port.
The configuration steps are listed below:
Switch(config)#ip igmp snooping
Multicast router
Group 1
IGMP Snooping
Multicast port
Group 1
Group 1 Group 2
Multicast Server 1
Multicast Server 2