XGS-5240-Series User Manual

Configuration Guide of XGS-5240-Series
39-6
no ipv6 dhcp use class
DHCPv6 server to support the
using of DHCPv6 class during
address assignment, the no
form of this command disables
it without removing the relative
DHCPv6 class information that
has been configured.
ipv6 dhcp class <class-name>
no ipv6 dhcp class <class-name>
This command defines a
DHCPv6 class and enters
DHCPv6 class mode, the no
form of this command removes
this DHCPv6 class.
Interface configuration mode
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
This command enables the
DHCPv6 server to support
selections when multiple
option 37 or option 38 options
exist and the option 37 and
option 38 of relay-forw in the
innermost layer are selected.
The no operation of it restores
the default configuration, i.e.
selecting option 37 and option
38 of the original packets.
IPv6 DHCP Class configuration mode
{remote-id [*] <remote-id> [*] | subscriber-id [*]
<subscriber-id> [*]}
no {remote-id [*] <remote-id> [*] | subscriber-id [*]
<subscriber-id> [*]}
This
command configures
option 37 and option 38 that
match the class in ipv6 dhcp
class configuration mode.
DHCPv6 address pool configuration mode
class <class-name>
no class <class-name>
This command associates
class to address pool in
DHCPv6 address pool
configuration mode and enters
class configuration mode in
address pool. Use no
command to remove the link.
address range <start-ip> <end-ip>
This command is used to set